Subject: Re: Vmax Manual Supplement 4-8 Thermostatic Switch test Water Coolant The switch will NOT operate in boiling water even if it is good, you must use coolant! 7-29 Pickup Coil Test O-B,O-Gy,O-W/G,O-W/R B-O,B-Gy,B-W/G,B-W/R Orange & Black wires swapped (Only applies to 85-89 models) - ------- Forwarded Message Follows ------- PAGE DESCRIPTION MANUAL PRINT CORRECTION NOTES 2-5 Firing Sequence 1 - 3 - 4 - 2 1 - 3 - 2- 4 2-5 Cyl.clearance sequence No 3, 4 & 2 No.1, 3, 2, 4 2-7 Exhaust valve clearance 0.00~0.05 0.11~0.15 Table incorrect " " 0.06~0.10 0.16~0.20 Add .10 to all EXHAUST " " etc etc measured clearance figures 3-67 Clutch picture labels 9,10,11,12,13,14,15,16,17,18,19,20,21,22,23,24 3-74 Install:Note: (I-4) (I-1) Mark on camshaft cap. 3-77 Install:3) (I-4 and E-4) (I-1 and E-1) Marks on camshaft caps. 8-3 Cylinder Bore Size 75.07 ~ 76.02 75.976 ~ 76.016 Maintenance Specifications " " (2.956 ~ 2.993 in) (2.991 ~ 2.993 in) inches ----------- Please add to this list any known corections to the VMAX service manual PAGE DESCRIPTION MANUAL PRINT CORRECTION NOTES 2-5 Firing Sequence 1 - 3 - 4 - 2 1 - 3 - 2- 4 2-5 Cyl.clearance seq. No 3, 4 & 2 No.1, 3, 2, 4 2-7 Exhaust valve clearance 0.00~0.05 0.11~0.15 " " 0.06~0.10 0.16~0.20 " " etc etc Table incorrect Add .10 to all EXH. measured clearance figures. 3-67 Clutch pic.labels 9,10,11,12,13,14,15,16,17,18,19,20,21,22,23,24 3-74 Install:Note: (I-4) (I-1) Mark on camshaft cap. 3-77 Install:3) (I-4 and E-4) (I-1 and E-1) Marks on camshaft caps. 4-8 Thermo.Switch test Water Coolant The switch will NOT operate in boiling water even if it is good, you must use coolant! 7-29 Pickup Coil Test. O-B,O-Gy,O-W/G,O-W/R B-O,B-Gy,B-W/G,B-W/R Orange & Black wires swapped (Only applies to 85-89 models) 8-3 Cyl. Bore Size 75.07~76.02 75.976~76.016 Maintenance Specs. " " (2.956~2.993 in) (2.991~2.993 in) inches