Date: Wed, 11 Jun 1997 16:57:52 -0700 (PDT) From: Kelly Cash Subject: Re: Heli Bars installation To: carlson@carlsons.com Cc: kelly.cash@Corp MIME-Version: 1.0 Content-MD5: w0TEB6Oqvy+FM2MGhyAQ8Q== > Installation question: How do you get the old bars off and how do you > install/fasten the Heli Bars on? In looking at my bars and the cast piece > the bar tubes slip into, I see that the bars are held in place with a pin. > How do you get the pin out? What do you use to hold the new bars in? It's really easy, less complicated than you think. 1. Use BIG wrench to take bar ends off. (don't bother with the phillips screw in the ends) 2. Take little plastic cap off of the other ends of the bars with small pointy object. Ice pick, small screwdriver. 3. Take left grip off. Blow air into it, use small thin object to pry it loose. No need to cut it off. 4. Loosen all switch pods, brake & clutch reserviors. 5. Loosen bars by taking out the allen bolts that were covered by the plastic caps. 6. Remove the bars, then slide the pods off them. 7. Reverse process with the heli-bars. Good luck! -K ========================================================================= Mr. Kelly Cash Desk: 415-614-6568 Sun Microsystems Computer Company FAX: 415-614-6590 1080 Marsh Road, MS MPK05-101 Email: kelly.cash@corp.sun.com Menlo Park, CA 94025 Alpha Pager: 2649241@skymail.com =========================================================================